How can I install and configure my lamination ribbon?

The patch or hologram ribbons have to be installed on the black spindles, inside the laminator as showed below. Push the ribbon to the maximum position:

After installing the ribbon, make sure the film is run through the middle of the back ribbon sensor (see picture below).

Note that the patch will not cover the whole surface of the card.

Go to the driver’s Properties menu, and then select the Lamination tab. Both the lamination speed and temperature can be changed to improve the lamination quality and solve this issue.
IMPORTANT: before sending a job, make sure to configure all patch settings appropriately and that Set Lamination Station button has been clicked (sends the information to the printer).